Gutter Wont Stay On Fascia Board Revit

Then locate the brackets underneath your gutter holding them in place and unscrew them so you can lift the gutter up and away from the fascia.

Gutter wont stay on fascia board revit.

As you click edges revit treats this as one continuous gutter. Usually a numeric value. Check the blue handles at the ends of the gutters and make sure they re both at the same location for each gutter piece. Comments about the roof fascia or gutter.

To create gutter down pipes in revit go to the systems tab pipe. The fascia is attached to the end of the roof and supports the lower edge of the bottom row of roof tiles. A label applied to roof fascia or gutters. The actual length of the fascia or gutter.

Leave the old spikes in place a spike head looks better than a hole in the gutter. Now if you re choosing a fascia sweep as the edge to host your gutters and the fascias don t exactly trim together at a corner then the gutter won t either and you ll have to manually pull the ends of the gutter together to miter the corners. It s a bummer revit doesn t let you demo selected parts of a fascia or a soffit. Your gutters sit right next to them.

Highlight horizontal edges of roofs soffits fascias or model lines and click to place the gutter. What happened is i d demolished the roof before i attempted to remove the fascia segments. Remove the gutter brackets from your fascia so you can reuse them on the new board. Unscrew the gutters from behind your existing fascia board with an electric screwdriver.

Click architecture tab build panel roof drop down roof. Since my phase filter was set to previous and new the roof was no longer visible and could not be selected. Your fascia boards are the long boards the run just under the roof. Watch the status bar for information about valid references.

One way to make sure your gutter doesn t fall off the house is to install fascia hanger brackets. To create gutters in revit go to the architecture tab roof dropdown gutter. Just hook the bracket under the front lip of the gutter and then screw the other side of the bracket to the fascia. Select the roof fascia leading edge which will be the point that your gutter hosts to.

You can use the blue arrows to flips the gutter orientation if necessary. Your gutters could be working well but if your fascia boards are rotten that s a problem. Revit issues a warning if the number is already used but allows you to continue using it. I have been modelling some roofs with gutters and have come across the limitation of not being able to assign a gutter to an edge that isnt perpendicular to a roof fall i have tried modelling the roof a number of ways by defining the slope at the edge using a slop arrow etc.