How to hang on plaster walls with a picture hanging system.
Hang shelf in plaster wall.
How to hang shelves on plaster walls step 1.
Hang the shelf on the mounting brackets.
The ideal solution for hanging pictures on plaster is to use a picture hanging system like the all in one click rail cable hanging kit.
Screws and screws with masonry anchors for heavy items are your best choice for hanging things on plaster walls without picture rail.
All you need to do is pre drill a hole slightly narrower than your screws then use the drill to drive a screw into the hole.
Position the shelf on the wall.
For lighter items simply screwing into the plaster with a 1 1 4 drywall screw is usually enough to get the job done.
Plaster walls with available studs locate the vertical studs in the wall where the shelving will be located by sliding an electronic stud sensor over that.
Use a stud finder to locate the studs within the walls.
Determine where you want your shelves and how wide they will be.
1m long level stud finder steel wall screws electric drill screwdriver pencil tape measure brackets shelf.
Make sure you leave half an inch out of the wall so you have space to hang your artwork.
Then check the shelf to make sure it s sturdy and ready to bear the weight of whatever you put on top of it.
Fit a floating shelf by pushing it onto the bracket instead.
Hold the shelf where you would like it to go and mark the height with a pencil this is where you ll screw in your brackets.
Place one of the brackets against the wall at the first shelf location.
With some setups the shelf rests on top of the brackets.
This system works by simply installing a rail along the wall and pictures then hang from cables attached to the rail and are fastened with hooks.
Use a spirit level to make sure everything is straight.
Determine the height.
Grab your shelf brackets place them up against the wall and mark where your screws will go.
Here is a list of items you ll need before you begin hanging your shelf on a plaster wall.
Hanging things on plaster walls is easy if you have a drill and screws.
Drill a pilot hole.
Mark your screw points.