The second trick is to set the molding against the saw and mark a line on the table with a pencil image 2.
Hanging crown molding on plaster walls.
After all it is just a piece of wood molding.
Use a level or laser level to extend this mark along the walls from corner to corner image 2.
Install chair rail approximately 34 inches above the floor.
Well obviously that was just a misfire so we upped the pressure in the tank and fired a few more.
One of the previous owners had tried to put up crown molding but the job was unfinished and looked bad so i pulled it down.
I repaired the plaster and have painted the walls and now want to put new crown molding up.
If you think something is too heavy then it s best to mount it in a more secure way to the wall.
I can still give you some great ideas for hanging on plaster walls.
Position the molding in the desired location on the wall.
Before installing crown molding test fit a piece of molding in place image 1 and mark the height of the molding where it meets the wall below the ceiling.
Make a marking gauge the same size as the crown then use it to position the crown on the rail.
If you don t have picture rail or don t want to install some that s just fine.
The furring strips add more stability to the larger heavier crown molding and greatly simplify nailing the molding to the wall.
Hanging without picture rail.
The nail came out of the gun into the crown molding and then did a 180 against the plaster walls and came back.
Popular in new england and southern townhouses during the victorian era picture rails may seem.
Cut the first piece square.
This type of molding was once an elegant way of hanging artwork on hard to penetrate plaster walls.
The number one trick to cutting inside and outside corner crown molding is to cut each piece upside down with the ceiling side on the bottom and the wall side on the top image 1.
Fastening crown molding directly to walls can be a headache but well fastened rail trim makes nailing the crown foolproof.