Hardiplank Siding Installation Guide

Install these fragile starter strips with a 15 gauge trim gun.

Hardiplank siding installation guide.

Install hardiplank siding with joints butted in moderate contact. To help you get your project done right the first time we ll be gathering tips answers to commonly asked questions and more about james hardie siding installation. Fasteners shall be installed between 1 in. Hardie plank siding is almost always installed with air nailers which are the best tool for quick installation.

We have dozens of installation specialists throughout the u s. From the ends of the plank. Installing siding wet or saturated may result in shrinkage at butt joints. James hardie the world leader in the manufacturing and development of fiber cement building products has created this website to help builders and contractors with the installation of james hardie siding trim soffit and accessories such as hardiewrap weather barrier along with the handling and installation of products with colorplus technology.

Protect edges and corners from breakage. James hardie prefers and recommends installation of hardieplank lap siding by the blind nailing technique such that fasteners are hidden by the course above. Snap a line 1 in. Carry planks on edge.

James hardie is not responsible for damage caused by improper. And canada who are available to work with any contractor or builder. Hardieshingle siding single family installation requirements hs1067 p1 8 04 18 store flat and keep dry and covered prior to installation. Optionally install the lap siding with a maximum 1 8 gap and caulk the joint see detail at right.

As a homeowner you will work with a contractor who will facilitate the installation of your james hardie siding trim soffit wrap and flashing products including products with colorplus technology. The first course of any wall should be installed over a 1 4. Snap another line for the bottom row of siding positioning it so it will hang down an additional 1 4 in. Hardiplank installation instructions.

The only downside of pneumatic tools is that sometimes the installer will get going a little bit too quickly and will lose track of where the nails are going. Instantly access installation info technical bulletins sds sheets more.